Click to Enlarge
The flip platform makes it easy to add and remove components in a setup without having to reposition them on the optical table.

• Designed for 90° Angular Adjustment
• Up to 180° Adjustment Range in Certain Configurations
• Side-Located Locking Cap Screw with 3/16" (5 mm) Hex
• 1.25" x 1.25" Mounting Platform with Eleven 8-32 (M4) Tapped Holes
• 8-32 (M4) Mounting Tap on the Side of Each Plate
• Four 8-32 Tapped Holes on the Bottom Plate for Additional Mounting Options
• Engraved Tick Marks in 15° Increments

The Adjustable Flip Platform is designed to attach to the top of our Ø1/2" or Ø1" posts and provide flexible mounting options for components. The flip platform can be secured on the post using the #8 (M4) counterbore located in the center of the bottom plate, or the 8-32 (M4) tapped mounting hole on the side of each of the two plates. The 1.25" x 1.25" top plate features eleven 8-32 (M4) tapped holes for mounting components.

The angle of the top plate can be adjusted between 0° and 90° with respect to the optical table surface when mounted using the counterbore in the center of the bottom plate. When mounted using the 8-32 tapped hole on the side, the top plate can be adjusted between -90° and +90° with respect to the optical table surface. In order to lock the platform in place, tighten the cap screw on the side using a 3/16" (5 mm) balldriver or hex key.

The flip platform can be converted between a right- and left-handed setup. Simply remove the locking screw, separate the top and bottom plates, flip the bottom plate upside-down, and reassemble the flip platform. This allows the user to choose the direction from which the locking screw is accessed, in case one orientation better suits the experimental setup.